For that case it's simple, but it is not general solution:
PE *.** CLASS(JESS) ID(JOER) ACC(A)
SETR RACLIST(JESS) REF
Remarks:
1. Depending on your JESSPOOL policy it is likely "all the power" for
SPOOL datasets. Maybe it's good for you and for non-prod system, but
generally it's too much. If you really care about the outputs, then
think about less generic profiles.
2. There are many ways to skin a cat or cancel a job. You can use MVS
CANCEL or JES2 $C commands.
3. Actually JESSPOOL profile is additional check from SDSF, so "pure"
command on console or SDSF log /command will not check that class profile.
4. While SDSF provides better flexibility and granularity than pure MVS
console, it also provide some complexity (more dependencies), which may
be misleading a little bit.
--
Radoslaw Skorupka
Lodz, Poland
W dniu 04.07.2025 o 18:18, Joseph Reichman pisze:
Hi
Would anyone know the racf command I guess it would be PERMIT command to
allow the specified user to cancel the following job
I was on SDSF DA panel typing in "C" to cancel the job
When I got the error below
SDSF DA S0W1 S0W1 PAG 0 CPU/L 10/*** NOT AUTHORIZED TO JOB
COMMAND INPUT ===> SCROLL ===>
PAGE
NP JOBNAME StepName ProcStep JobID Owner C Pos DP Real Paging
SIO
C DBGRSERV DBGRSERV DBGRSERV STC01219 START1 IN C0 326 0.00
0.00
ICH408I USER(JOER ) GROUP(SYS1 ) NAME(JOSEPH REICHMAN )
S0W1.START1.DBGRSERV.STC01219 CL(JESSPOOL)
INSUFFICIENT ACCESS AUTHORITY
FROM *.** (G)
ACCESS INTENT(ALTER ) ACCESS ALLOWED(READ )
***
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
