Dear all, I have a question about the RMF III Device Resource Delay report
I noticed that the DLY% value of one disk is 100 every 6 minutes. This disk has HyperPAV enabled. ACT RATE = 5.1,RESP TIME=200 ACT%=2 CON%=1 DSC%=1 USG%=0 DLY%=100 According to the IBM manual, DLY% means "Percentage of time when the job was waiting to use the data set because of contention for the volume were the data set resides". I would like to know how to identify the cause of this contention. What command should I use? Do I need to enable GRS MONITOR? Any suggestions would be greatly appreciated! Thank you for your attention and assistance. Sincerely, Jason Cai ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
