There was a time when ACCEPT NOAPPLY followed by a Stage 1 Sysgen, a Stage 2 Sysgen and a JCLIN was a common method for installing operating systems and program products. Most shops opted for IPO et al rather than going that route.
-- Shmuel (Seymour J.) Metz http://mason.gmu.edu/~smetz3 ________________________________________ From: IBM Mainframe Discussion List [[email protected]] on behalf of CM Poncelet [[email protected]] Sent: Saturday, June 18, 2022 11:31 PM To: [email protected] Subject: Re: SMPe ACCEPT process In the 1980's, IMS SYSMODs (CBIPO/CBPDO etc.) had to be accepted before they could be applied. It might have had to do with the macros needing to be accepted before the rest of it could be applied. Not sure how it is done now. The last IMS *native SMP/E* CBIPO I did was in 2000 - probably an accept then apply 'as usual' but I can't remember. On 17/06/2022 16:05, Ed Jaffe wrote: > On 6/16/2022 3:02 PM, Bill Giannelli wrote: >> For my prior maintenance I have run an APPLY excluding several PTFs >> due to PEs and specified several bypass options. >> But when running an ACCEPT do I run WITHOUT the excludes and the bypass? > > Nothing will be accepted that hasn't already been applied. > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
