On 6/13/2022 8:21 PM, Binyamin Dissen wrote:
At any rate, I wanted to allow task! a quantum of processing time before allowing task2 to continue. After that I do not care if they run in parallel.
You can ATTACH[X] with DISP=NO. That prevents the subtask from running at ATTACH time.
You can make it dispatchable at your leisure using the STATUS RESET service. We do this in one of our products and it works very well. -- Phoenix Software International Edward E. Jaffe 831 Parkview Drive North El Segundo, CA 90245 https://www.phoenixsoftware.com/ -------------------------------------------------------------------------------- This e-mail message, including any attachments, appended messages and the information contained therein, is for the sole use of the intended recipient(s). If you are not an intended recipient or have otherwise received this email message in error, any use, dissemination, distribution, review, storage or copying of this e-mail message and the information contained therein is strictly prohibited. If you are not an intended recipient, please contact the sender by reply e-mail and destroy all copies of this email message and do not otherwise utilize or retain this email message or any or all of the information contained therein. Although this email message and any attachments or appended messages are believed to be free of any virus or other defect that might affect any computer system into which it is received and opened, it is the responsibility of the recipient to ensure that it is virus free and no responsibility is accepted by the sender for any loss or damage arising in any way from its opening or use. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
