On Wed, 16 May 2012 11:14:36 +0200, R.S. <[email protected]> wrote:
>W dniu 2012-05-15 20:33, Mark Zelden pisze: >>> What's wrong??? >>> >>> >> >> User error? :-) Did you change the SYSID or anything like that? >> When you use the LOG command do you see an ISPF short message >> error? >> >> Try "SYSID ?" and see what it says. >> Then SYSID with no operands. > >1. SYSID > >SYSID *was changed* recently. > >The command SYSID ? shows: > >JES SYSIDS=(NEW1),OLD1 > >and in the command line there appears text SYSID NEW1 > >Remarks: >Expected output from SYSID ? is JES SYSIDS=(NEW1) (tested on other systems) >I issued SYSID NEW1 - no effect >I issued SYSID OLD1 - and could not enter LOG (no msg) >I issued SYSID WRNG - and could not enter LOG (no msg) >MAS panel shows: > OLD1 DRAINED,P > NEW1 ACTIVE >(system is not sysplexed, PLEXCFG=MONOPLEX) > > >2. SYSLOG - OPERLOG >My "log default" is SYSLOG, previously I had "OPERLOG only if Operlog is >active on your system". >I enter syslog by typing LOG or LOG S. >WHen I type LOG O I get the following message: >ISF036I NO RECORDS TO DISPLAY > > >3. LOG content >Real syslog content is accessible under ST, entry SYSLOG +MASTER+ >LOG panel always show last few messages from last "live" - it contains >information since previous IPL to SHUTDOWN. No current information. > > Running out of ideas here. :-) 1) Delete your ISFPROF from your userid.ISPPROF data set and try again. If this fixes the problem, I think you've run into a bug that should be reported to IBM if you want to spend the time doing so. 2) What is your syslog output class? Is there any of it left in the spool that could be from the old SYSID? If so, delete it all. Do a "WRITELOG" command and then try again. Regards, Mark -- Mark Zelden - Zelden Consulting Services - z/OS, OS/390 and MVS mailto:[email protected] Mark's MVS Utilities: http://www.mzelden.com/mvsutil.html Systems Programming expert at http://expertanswercenter.techtarget.com/ ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
