On Tue, 15 May 2012 12:14:11 -0400, Crabtree, Anne D <[email protected]>
wrote:
>Trying to bring up z/os v1r13 for first time on my onepac system and I keep
>getting error message ICH571A Error building program control tables followed
>by ICH501I saying RACF is not active. I performed a system upgrade when
>installing and my 1.11 onepac system comes up fine with these RACF datasets.
>I have to have missed something !!
>That being said, I have checked the following:
>
>My IEFSSNxx member has:
> SUBSYS SUBNAME(RACF)
> INITRTN(IRRSSI00)
> INITPARM(';,X')
>
>The RACF proc is in CPAC.PROCLIB and looks ok.
>IRRSSI00 module is in SYS1.LINKLIB.
>I get messages that the installation router table and the class descriptor
>table were processed.
> I'm also getting this error (but I think it's just because RACF didn't start
> and is not the problem):
>
>ICH584i ICHEINTY next error against profile irrplex_ in class gxfacili on
>the database with master dataset "my dataset name" on "my volume" rc=0000001C
>reas=00000000
>
>Any suggestions?
>
>
>
The RACF proc doesn't matter. It isn't even needed.
Are you sure your DSNT is correct for your onepack system? Are the data sets
cataloged properly? You could add them to MSTRJCLxx also. Are you using
a DSNT with sysplex mode enabled? You should change that for your onepak
or ZAP it (see the ONEPAKZ* / TWOPAKZ* examples on my web site).
Regards,
Mark
--
Mark Zelden - Zelden Consulting Services - z/OS, OS/390 and MVS
mailto:[email protected]
Mark's MVS Utilities: http://www.mzelden.com/mvsutil.html
Systems Programming expert at http://expertanswercenter.techtarget.com/
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
