If you have system automation table or just a Netview automation table, you can
trap the message and
run a Rexx clist that issues WTO commands and sets the descriptor codes.
Run HELP WTO on Netview for more info.
DESC, WTO.DESC
The descriptor codes for the WTO, specified as a list of
numbers in parentheses:
DESC
.-,---------------.
V |
>>-+------+--DESC = '(---+-------------+-+-)'------------------><
'-WTO.-' '-number_1-16-'
You can also specify specific numbers and a range of numbers,
for example:
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of
ibmnew
Sent: Thursday, October 27, 2011 11:41 PM
To: [email protected]
Subject: How to make console alert with sound
hi all
We want to use MPFLSTxx for the messages which we want them sound when issued
A display console can have the following feature:
An audible alarm is available on display consoles. The system sounds
this alarm when certain changes in conditions occur, such as when you
enter an invalid CONTROL command. WTO macros with descriptor codes of
1, 2, or 11, and all WTOR macros will cause the audible alarm to sound
on operator consoles so-equipped.
Could you tell us how to do it? Thanks a lot!
Best Regards,
Jason Cai
-
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
