Dear list, especially Thomas,
Since some time in the last few weeks something is broken in the hugin
control points editor panel:
Assuming I have auto-add and auto-finetune turned off, if I click in one
image and the other image, I get a pair of 'new' points. It used to be
possible to press 'a' to add this pair. Now this doesn't do anything,
but I can press the 'add' button in the lower right corner. Now it used
to be possible to finetune the point positions of this new pair by
pressing 'f', however, this doesn't do anything any more. I can,
however, press the finetune button, or alternatively select a different
pair, and reselect the newly added pair: then pressing 'f' works.
Additionally, while a point pair is in a 'new' state, or has been added
but not yet de+reselected, zooming via '0', '1', '2' doesn't work.
I assume this isn't intentional? Is it obvious where this behaviour
comes from or shall I have a go at bisecting it (it must be very recent)?
cheers, lukas wirz
--
A list of frequently asked questions is available at:
http://wiki.panotools.org/Hugin_FAQ
---
You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/hugin-ptx/cb5fe66c-6127-4f47-8f41-12a1d3375272%40posteo.net.
