As usual I find my answer minutes after posting a question. It's as if formulating your question correctly makes you smarter!
The command line tool to use is pto_var with either --modify-opt --opt=something-something or just opt=something-something (and then -o output.pto input.pto) To know how to get the exact same result as any selected item in the GUI dropdown I used a text diff tool (Meld). ------- Original Message ------- On Tuesday, April 5th, 2022 at 12:49 PM, 'ChameleonScales' via hugin and other free panoramic software <[email protected]> wrote: > When you change the type of geometric optimisation from the GUI's dropdown > (Position, View, etc...), it not only changes the value of > optimizerMasterSwitch in the pto but also adds or removes lines under this > line: > # specify variables that should be optimized > > I tried running the same autooptimiser command on 2 pto files, one where only > the value of masterswitch is changed and the other where also the other lines > were added by saving from the GUI. The results came entirely different. > > So here's my question : is there a command to properly change the type of > geometric optimization in a pto ? That is, add or remove the necessary lines > without using the GUI dropdown ? > > optimize optimise optimizer optimiser > (I'm optimizing the searchability lol) > > -- > A list of frequently asked questions is available at: > http://wiki.panotools.org/Hugin_FAQ > --- > You received this message because you are subscribed to the Google Groups > "hugin and other free panoramic software" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > [https://groups.google.com/d/msgid/hugin-ptx/eNRyURvmKoijtM6ig90XxskNfpF1oqqKY7sgBIquQVFe8YLONmRc0ITfyi0br-hu8XXCpju0YnON_8nEiJRmtnMET5XBa5_-yTDb0Q5Tk3w%3D%40protonmail.com](https://groups.google.com/d/msgid/hugin-ptx/eNRyURvmKoijtM6ig90XxskNfpF1oqqKY7sgBIquQVFe8YLONmRc0ITfyi0br-hu8XXCpju0YnON_8nEiJRmtnMET5XBa5_-yTDb0Q5Tk3w%3D%40protonmail.com?utm_medium=email&utm_source=footer). -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/ghifmb025FkrwfsYTZF_0KbWasepmEk41ZyxlIoguxZHcXAWUR3c_rv0LvO8wKBTo8OZ9-Ss-x_fGBcbS2degKOpaQj0G241-vaWnPFVMgs%3D%40protonmail.com.
