Re: route learning

[t3sserakt]

On 31.07.22 18:00, help-gnunet-requ...@gnu.org wrote:

----------------------------------------------------------------------

Message: 1
Date: Sun, 31 Jul 2022 11:30:04 +0200
From: ToBo <t...@rechnerpool.de>
To: Help-gnunet <Help-gnunet@gnu.org>
Subject: Re: route learning
Message-ID: <a22a8eff-9ef1-4da0-b670-22ee52003...@rechnerpool.de>
Content-Type: text/plain;       charset=us-ascii

Hi,

29 juli 2022 kl. 22:58 skrev Martin Schanzenbach <mschanzenb...@posteo.de>:
Excerpts from ToBo's message of 2022-07-29 14:23:48 +0200:

I set up a three nodes in a very simple configuration: A and B is behind NAT, 
so they both have to communicate with each other through C

A   ->   C   <-   B

All nodes are in friend only mode. All nodes have some knowledge of each other, at least you can 
see infos in "gnunet-peerinfo" or "gnunet-peerinfo -f" (what is the exact 
difference anyway?)

Do you have any actual connections?
Try with "gnunet-core".

I mainly used gnunet-transport to monitor that, but yes, gnunet-core
has shown the same.

Why does a gnunet-cadet don't find it's way from A to B ?

This may be due to many reasons. Try compiling gnunet with
"--enable-logging=verbose" and set the debug level for cadet to DEBUG.
Then check logs.
That would be my first approach (IF you have connections at all see
above).

I recompiled it and tried again, this time it worked for whatever
reason. Sometimes the behavior of GNUnet is hard to understand.

How can I configure a minimal set of deamons to just have a network or session
layer with cadet? I think this will help in understanding the whole thing.

src/fs/fs.conf

There you see at the very beginning

[fs]
START_ON_DEMAND = YES
IMMEDIATE_START = YES



- t3sserakt

Each service can have a section in the configuration file, if you like to change the default values. You can have a look onto the default values in the source code. For example to look for the default values of the file sharing service you might have a look into the file If you change IMMEDIATE_START to NO. This service will not start when starting the GNUnet peer, but if it is needed. If you change START_ON_DEMAND to NO it will not start at all.

OpenPGP_0x524982A0100F7490.asc
Description: OpenPGP public key

OpenPGP_signature
Description: OpenPGP digital signature