On 5 September 2011 22:51, Aleš Nesrsta <star...@volny.cz> wrote:
> Hi,
>
> I think it is not GRUB related problem, more probably there is some HW
> problem on Your serial port. Try to check idle voltage on RxD pin of
> serial port (best with oscilloscope... :-) ). Or You can have some
> unwanted "leakage" between pins of connector or wires in cable (check
> resistance between wires of cable) etc.
>
> Normal serial port should NEVER do anything if there is nothing
> connected to it. According to RS232 (V24) specification there should be
> voltage in range from -12V to -3V on RxD pin in idle state (in simplest
> case there is some internal pull-up resistor connected from RxD to -Vcc
> directly inside UART or something else...).
> In this normal case nothing is received by serial port and nothing will
> be interpreted as keypress in GRUB, i.e. GRUB will boot normally.
>
> In Your case, probably something causes some noise on RxD pin or there
> is bad voltage level on RxD pin (e.g. >= +3V or near to 0V etc.) when
> nothing is connected - so serial port interprets it as receiving some
> character(s).
> When You connect Your serial port to another device (notebook in Your
> case), RxD is set to correct idle voltage from connected idle TxD, so
> the problem is corrected.
>
> From my long praxis with serial ports on different PCs and another
> (non-PC) devices, manufacturers very very often don't respect RS232
> (V24) specification (mainly for RxD/TxD signals voltage levels). It
> often caused bad situations, some of them were in fact the same as Your
> case.
>
> Using of DTR line is fine but if You have some HW problem on RxD line,
> there could be the same problem also on DTR (RTS, CTS ...) line and
> final effect will be the same...
> Additionally, lot of devices are working without using any additional
> link/modem state signals (i.e., only signals RxD, TxD and GND are used),
> it is simplest and almost working solution (and working well - of course
> it depends of kind of communication and it also expects that RS232
> specification is not violated and all HW is in order...).
>
FWIW I am using
description: Motherboard
product: DQ45CB
vendor: Intel Corporation
physical id: 0
version: AAE30148-302
Since the BIOS does not support serial boot it is not tested for this
I guess. I don't have an oscilloscope so I can't tell what is going on
on the wires.
Is there some alternative to using the onboard port? Does Grub support
some serial addon cards?
Also since this seems to be a common problem with PC hardware perhaps
a warning in the manual and the configuration file should be added.
Thanks
Michal
_______________________________________________
Grub-devel mailing list
Grub-devel@gnu.org
https://lists.gnu.org/mailman/listinfo/grub-devel
