You can change the size of the shhet tabs area by dragging the handle to the right.
Regards, Jean Le jeudi 21 janvier 2010 à 11:49 -0500, chris dunn a écrit : > Gnumeric has started a very annoying habit of opening up a box to the > left of the Information Area (bottom right corner of the display) in > width so that the width of the display of tab names is much reduced. > This results in only being able to see a small number of the sheet tab > names instead of a full-width display showing a larger number of sheet > tab names. I'm not sure what this box is called or what is it's > function. > > Now I'm sure this didn't use to happen, and when I opened one of my > sheets with lots of tabs I could see all (or very many) of the sheet > tab names in almost the full-width of the display after opening the > sheet. As far as I recall this spacing remained static, and there was no > attempt by the box left of the Information Area to hijack the space. > Perhaps there was no such box? > > Now when I open a sheet I seem to get a fairly normal sized Information > Area, an empty box to the left of the IA taking up about 2/3 of the > display width, and a small area to the left of that with just a couple > of the tab names shown. There is a handle left of the empty box which > allows me to minimise its width and display more tab names. Fine, but > then while I'm working this rogue box once again widens and closes down > the tab names so that I have to keep going through the process of > reducing the box width. > > Am I the only one suffering from this infuriating behaviour or is it an > aggravation to others also? Am I missing something obvious which would > allow me to control this rude box? What is the box for? Can I dispense > with it? > > Help, please. > > _______________________________________________ gnumeric-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/gnumeric-list
