I was not able to install the swig2.0...... says it's not available and there is something else.
I looked and found that swig2.0 is quite old and the newer version is 3.xxx or something. Do I need the newer version? so, I DL the gnucase file then extract it.... do I need to create the gnucase file? I would then cd to the gnucase folder and run the second part of the directions. D On Sat, Apr 28, 2018 at 3:43 PM, Geert Janssens <geert.gnuc...@kobaltwit.be> wrote: > Op zaterdag 28 april 2018 16:33:21 CEST schreef Dennis Powless: > > I just installed ubuntu 18.04 LTS on my dual boot machine. I want to > > install v 3.0 and the new ubuntu only has 2.6.19 in the software center. > > What is the best method to get v3.0 installed instead of the older > version? > > > > I see instructions here.... > > https://wiki.gnucash.org/wiki/Building > > > > And scrolled down I see these instructions..... I'm assuming this will > > work for 18.04LTS? > > Ubuntu 16.04 LTS (Xenial Xerus) > > > > To build Gnucash 3.0 from source you need to install following packages: > > > > sudo apt-get install cmake > > sudo apt-get install libtool libltdl-dev > > sudo apt-get install libglib2.0-dev > > sudo apt-get install icu-devtools libicu-dev > > sudo apt-get install libboost-all-dev > > sudo apt-get install guile-2.0 guile-2.0-dev > > sudo apt-get install swig2.0 > > sudo apt-get install libxml++2.6-dev > > sudo apt-get install libxslt1-dev > > sudo apt-get install xsltproc > > sudo apt-get install libgtest-dev > > sudo apt-get install google-mock > > sudo apt-get install gtk+3.0 > > sudo apt-get install libgtk-3-dev > > sudo apt-get install libwebkit2gtk-4.0-37 > > sudo apt-get install libwebkit2gtk-4.0-dev > > sudo apt-get install libdbi-dev > > > > mkdir build-cmakecd build-cmake > > cmake -D CMAKE_INSTALL_PREFIX=<target>/gnucash-cmake -D > > WITH_AQBANKING=OFF -D WITH_OFX=OFF ../gnucash > > make > > sudo make install > > > > > > I'm assuming I would then change the <target> with the downloaded gnucash > > file, right? > > No. The target is where you want gnucash to be installed. The downloaded > gnucash file should be extracted into a directory named "gnucash". And the > cmake command as used in these instructions should be run from within a > directory *next* to this "gnucash" directory, not from a directory > *inside* > it. You can read the generic instructions higher on that page to > understand > all the details. > > Good luck! > > Geert > > > _______________________________________________ gnucash-user mailing list gnucash-user@gnucash.org To update your subscription preferences or to unsubscribe: https://lists.gnucash.org/mailman/listinfo/gnucash-user If you are using Nabble or Gmane, please see https://wiki.gnucash.org/wiki/Mailing_Lists for more information. ----- Please remember to CC this list on all your replies. You can do this by using Reply-To-List or Reply-All.
