John, The wiki page (http://wiki.gnucash.org/wiki/Documentation_Update_Instructions <http://wiki.gnucash.org/wiki/Documentation_Update_Instructions>) gives different commands than these. Specifically, the commands for the docs are listed there as:
cd docs/guide/C xmllint --valid --noout gnucash-guide.xml xsltproc -o ../../../output_html/ ../../xsl/general-customization.xsl gnucash-guide.xml cd docs/help/C xmllint --valid --noout gnucash-help.xml xsltproc -o ../../../output_html/ ../../xsl/general-customization.xsl gnucash-help.xml Perhaps you were crossing up the application compilation with the docs compilation? David > On Feb 25, 2016, at 11:18 AM, John Ralls <jra...@ceridwen.us> wrote: > > So far so good. There's one more step you should do before committing: > configure and run make && make check. Make check will run some XML checks to > make sure your change complies with the DocBook DTD. After running make > you'll have an HTML version of the doc with your changes which you can review > in your browser which is a bit friendlier for proof-reading. The instructions > are on the wiki Documentation page; I'll repeat them here for your > convenience: > > mkdir build > cd build > ../configure > make > make check > > To view e.g. the guide in your browser, type in the following URL. It assumes > that you put gnucash-docs in your user directory and that you made your user > "sunfish42". Adjust as necessary and notice the 3 slashes after file: _______________________________________________ gnucash-devel mailing list gnucash-devel@gnucash.org https://lists.gnucash.org/mailman/listinfo/gnucash-devel
