On Feb 25, 2012, at 10:28 AM, Reuben Cummings wrote: > The scrollback in the terminal doesn't go back far enough to show > that. It use to give the failed to unpack error (even after > installing xzip) but now it only gives the autoreconf error. Now, the > only gtk+ lines are > > *** Checking out gtk+ *** [26/73] > *** Configuring gtk+ *** [26/73] > autoreconf -fis && ./configure --prefix /Users/admin/gnucash-stable > --libdir '/Users/admin/gnucash-stable/lib' --with-gdktarget=quartz > --enable-quartz-relocation > autoreconf: `configure.ac' or `configure.in' is required > *** Error during phase configure of gtk+: ########## Error running > autoreconf -fis && ./configure --prefix /Users/admin/gnucash-stable > --libdir '/Users/admin/gnucash-stable/lib' --with-gdktarget=quartz > --enable-quartz-relocation *** [26/73] > ......... > ......... > *** the following modules were not built *** [73/73] > gtk+ meta-gtk-osx-core gnome-keyring-28 libgnomeui meta-gtk-osx-webkit > goffice gnucash > > And I'm on MacOSX 10.7.2 Lion.
Why are you continuing after an error? Do you think that the dependencies are built just to waste time? Run jhbuild build again, but when it stops for failing autoreconf on gtk+, select "wipe directory" and reply "yes" when it asks if you're sure. If it stops again, copy the output starting with the "yes". Regards, John Ralls _______________________________________________ gnucash-devel mailing list gnucash-devel@gnucash.org https://lists.gnucash.org/mailman/listinfo/gnucash-devel
