On 5/29/13 9:19 AM, Sathish Kumar wrote:
Dear Sir,
In pulling simulations how to set pull_rate and
pull_k .On which basis we can set these values.
There is no systematic way to set these values, at least none that I know of.
Everyone has their own impression of what is "right" throughout the literature.
The burden of proof is on you to show that your settings don't lead to
anomalous behavior. Pull too fast or strong and you might deform some essential
part of your system. Pull too slowly or weakly and you may never see the
behavior you wish to observe. Try a systematic analysis of different rates and
constants to see (1) what combinations actually work and (2) which of those
combinations are practical for the scope of what you are doing.
-Justin
--
========================================
Justin A. Lemkul, Ph.D.
Research Scientist
Department of Biochemistry
Virginia Tech
Blacksburg, VA
jalemkul[at]vt.edu | (540) 231-9080
http://www.bevanlab.biochem.vt.edu/Pages/Personal/justin
========================================
--
gmx-users mailing list gmx-users@gromacs.org
http://lists.gromacs.org/mailman/listinfo/gmx-users
* Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
* Please don't post (un)subscribe requests to the list. Use the
www interface or send it to gmx-users-requ...@gromacs.org.
* Can't post? Read http://www.gromacs.org/Support/Mailing_Lists
