On 2011-03-11 19.53, Thomas Koller wrote:
I have version 4.0.5 and there is no enthalpy in the g_energy tool. Do you see
a chance to calculate the isobaric heat capacity as well as the thermal
compressibility, which is also not shown?
Thomas
Then you have to compute the enthalpy yourself by summing Etot and
pressure times volume (use the applied pressure, not the measured
pressure). Based on this you can look up the equations to compute the
heat capacity. Check the manual for quantum corrections to harmonic
potentials, however this is not trivial, in fact it is an open question
that we are trying to address in a paper under review.
The alternative may be to redo the sim in gmx 4.5.3, where the enthalpy
is stored in the edr file and some of the analysis is automated better.
--
David van der Spoel, Ph.D., Professor of Biology
Dept. of Cell & Molec. Biol., Uppsala University.
Box 596, 75124 Uppsala, Sweden. Phone: +46184714205.
[email protected] http://folding.bmc.uu.se
--
gmx-users mailing list [email protected]
http://lists.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to [email protected].
Can't post? Read http://www.gromacs.org/Support/Mailing_Lists
