This sounds like you, or your sysadmin, killed the job. It is also
possible if you are using a cluster that there is a walltime limit and
you exceeded that, so your job was sent the term signal.
You should restart the run. Check the manual on how to do that since
it depends on what version of gromacs you are using.
I sent a mail like this a few hours ago, but it didn;t seem to go
through, so I am resending.
Chris.
-- original message --
Hi all,
I have been running a simulation of 200 ns length and it suddenly
stoped at 67 ns showing the following line -
Received the TERM signal, stopping at the next step
I have checked the time steps properly and there is no error. What should I do
now? Please suggest.
Thanks
--
gmx-users mailing list gmx-users@gromacs.org
http://lists.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at http://www.gromacs.org/search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to gmx-users-requ...@gromacs.org.
Can't post? Read http://www.gromacs.org/mailing_lists/users.php
