Dear All,
I have in a mdrun.mdp file following settings:
; mode for center of mass motion removal =
comm-mode = Linear
; number of steps for center of mass motion removal =
nstcomm = 1
; group(s) for center of mass motion removal =
comm-grps = Protein SOL
This causes following warning/ error in the log file:
...
Large VCM(group SOL): -0.00020, 0.00161, 0.00109, T-cm: inf
Large VCM(group rest): -0.00238, -0.01596, -0.10896, T-cm: inf
Large VCM(group SOL): 0.00006, 0.00002, -0.00005, T-cm: inf
Large VCM(group rest): -0.00009, 0.00483, 0.00106, T-cm: inf
...
For a small testrun on 8 CPU (xtc: 2MB, trr: 22MB) I get 8 logfiles which are
due to this warnings 160 Mb each.
I looked the error Message up in the Gromacs mailinglist and found following
question [2] but no solution :-( .
The Gromacs manual also didn't helped, there was only one line on page 137.
1: http://www.Gromacs.org/pipermail/gmx-users/2008-April/033316.html
If I use in the mdrun.mdp file one of the following options "comm-grps=Protein"
or "comm-grps=SOL" or "comm-grps=SYSTEM" or ";comm-grps=" the warning does not
appear in the log file.
I would like to know:
1. What does the option "comm-grps = Protein SOL" physical mean?
a) Does it mean:
The protein and solvent atoms may have a initial drift. Merge all PROTEIN and
SOL atoms into a single group. Calculate the center of mass of this merged
group and reset the center of mass motion of this merged group in every step?
b) Or does it mean:
For example because of initial setup "error" all the solvent atoms have a
global drift in one direction and all the protein atoms have a drift in a other
direction.
Calculate for both groups seperatly the center of mass and remove for each
group the center of mass motion seperatly.
2. If the option "comm-grps = Protein SOL" physical means (1b) what do I have
to change in my simulation setup to avoid the warnings/ error "T-cm: inf" in
the log files?
3. Are the messages "... T-cm: inf" in the logfile a error or just a warning.
Can I just ignore the messages or do I have to adjust my inputfile?
4. If I'm allowed to ignore the warning, how do I tell Gromacs not to write
them in the log file. For a middle size simulation the logfile will use up my
entire diskspace before the simulation has ended.
Thanks
Emal
--
Der GMX SmartSurfer hilft bis zu 70% Ihrer Onlinekosten zu sparen!
Ideal für Modem und ISDN: http://www.gmx.net/de/go/smartsurfer
_______________________________________________
gmx-users mailing list gmx-users@gromacs.org
http://www.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at http://www.gromacs.org/search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to [EMAIL PROTECTED]
Can't post? Read http://www.gromacs.org/mailing_lists/users.php
