Hi,
Is there a way to update the stat information recorded in the index without
reading the file content from disk?
Starting from a clean working copy with a committed `file`, I'd like
touch file
git <magic-command> file
to bring the index into essentially the same state as
touch file
git status
but without reading the content of `file`. (I'd be willing to wait a bit
between touch and the magic command, to avoid any racy-git-related code paths.)
`git-update-index --assume-unchanged` is related. But it requires completely
manual handling of changes, because git will not look at marked files until
told otherwise with `--no-assume-unchanged`. I'd like to tell git only that
the current file content is known to be up-to-date. Any future changes should
be handled as usual.
In the documentation, `git add --refresh file` sounds a bit like what I'm
looking for. The documentation of `--refresh` states: "Don’t add the file(s),
but only refresh their stat() information in the index." But it doesn't do
what I want.
I looked a bit into `read-cache.c`. The comment above `refresh_cache_ent()`
sounds promising:
"refresh" does not calculate a new sha1 file or bring the
cache up-to-date for mode/content changes. But what it
_does_ do is to "re-match" the stat information of a file
with the cache, so that you can refresh the cache for a
file that hasn't been changed but where the stat entry is
out of date.
But it isn't obvious to me whether what I'm looking for is available. All code
paths that eventually reach `fill_stat_cache_info()` seem to go through
`ce_compare_data()` and therefore `index_fd()`, which reads the data from disk.
Steffen--
To unsubscribe from this list: send the line "unsubscribe git" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
