On Sonntag, 17. Februar 2008, Jens Krahe wrote: > Am Sonntag, 17. Februar 2008 schrieb Volker Armin Hemmann: > > On Sonntag, 17. Februar 2008, Jens Krahe wrote: > > > Am Samstag, 16. Februar 2008 schrieb Andrew Gaydenko: > > > > Ehci module is loaded, all MB USB ports are USB 2 ports, printer is > > > > "USB 2 (Full Speed)" printer. > > > > > > And there is nothing wrong. EHCI handles only the High Speed mode of > > > USB2! Low and Full Speed are still handled by UHCI/OHCI. > > > > you are wrong, kernel with ehci only: > > > > [ 31.592651] usb 1-3.1: new low speed USB device using ehci_hcd and > > address 4 > > And the device works? > 31.984912] usb 1-3: new high speed USB device using ehci_hcd and address 2 [ 32.109390] usb 1-3: configuration #1 chosen from 1 choice [ 32.109727] hub 1-3:1.0: USB hub found [ 32.110081] hub 1-3:1.0: 4 ports detected [ 32.437368] usb 1-5: new high speed USB device using ehci_hcd and address 3 [ 32.566492] usb 1-5: configuration #1 chosen from 1 choice [ 32.753643] usb 1-3.1: new low speed USB device using ehci_hcd and address 4 [ 32.856094] usb 1-3.1: configuration #1 chosen from 1 choice [ 32.867755] input: Logitech USB Receiver as /class/input/input3 [ 32.880583] input: USB HID v1.11 Mouse [Logitech USB Receiver] on usb-0000:00:02.1-3.1 [ 32.886684] input: Logitech USB Receiver as /class/input/input4 [ 32.913844] input: USB HID v1.11 Device [Logitech USB Receiver] on usb-0000:00:02.1-3.1
so it is the mouse/receiver of the mouse. And yes, it works perfectly fine. I have ohci support compiled as module - but the module is never loaded. -- gentoo-user@lists.gentoo.org mailing list
