Also, make sure that net.lo is turned on. I had a problem a while ago
with KDE taking forever to boot & interact because net.lo wasn't
starting in the init scripts. I guess its required.
Just something to try and help out.
bryce
Richard Fish wrote:
On 1/29/06, Korondi Márk <[EMAIL PROTECTED]> wrote:
Hi, everyone
Yesterday I reinstalled gentoo, because I'd made the filesystem dirty (always
used sudo, and installed programs not in portage randomly...) and I want a
new, clean system.
With Gentoo there is almost always an easier way than
re-installing...but too late for that now.
I install new kde (3.5.0), but there is a problem:
While other programs - firefox, gftp, bittorrent - run fine, all of my
programs using some kdelib or ,if I'm right, DCOP start slowly, and after
starting cannot run fine.
For example: KDE starts up slower than in the previous installation. Then I
pick konqueror, it takes 2-3 secs. to start. Then I close, and re-exec it.
2-3 secs again (where is the cache?). BUT: KHTML starts to render the page,
it hangs for 2 seconds, then begin to load. hmmm... Clicking refresh causes
the same.
Might be a prelinking issue...do you set KDE_IS_PRELINKED? And if so,
is it really pre-linked?
Running strace with the -tt option can also give you an idea of what
the KDE application is doing during that 2-3 second delay.
-Richard
--
gentoo-user@gentoo.org mailing list
