not on PE800 but on PE1300 with scsi disks and no raid controller,
the hardest thing to do was getting that poweredge boot off a livecd.
It didn't boot with the livecd untill I connected an old ide drive.
With that old drive the livecd boot was ok, then checked output of dmesg, and I could use the scsi drives also. And the tape drive even works, after change a scsi bios setting :)
I also found that the dell forums had quite a bit info about scsi and raid controllers and how to used them with linux.
Peter
On 8/3/05, Devraj Mukherjee <[EMAIL PROTECTED]> wrote:
Hi Everyone,
Is there anyone out there who has installed Gentoo Linux on a Dell
PowerEdge 800 system with a CERC hardware RAID controller?
If so what drivers are required?
Devraj
---
Devraj Mukherjee ( [EMAIL PROTECTED])
Eternity Technologies Pty. Ltd. ACN 107 600 975
P O Box 5949 Wagga Wagga NSW 2650 Australia
Voice: +61-2-69717131 / Fax: +61-2-69251039
http://www.eternitytechnologies.com/
--
gentoo-user@gentoo.org mailing list
--
I have plenty of common sense,
I just choose to ignore it.
--- Calvin
