> Hello, > > We'll I've got a new samsung monitor 2333HD-1 > that is verified 1920x1080. > > Finally, I got it working on a dvi-d-2-dvi-d video cable > with no problems...(minimal xorg.conf) and ati-drivers. > > > OK, so I switch to a DVI-D<on video card> to HDMI > on the monitor and it comes in, but the bottom and sides > are missing.
Can you set overscan to 0% in the ATI Catalyst Control Center. Does that make a difference? > > OK so I found this thread that I'm guessing is > on the mark: > http://www.phoronix.com/forums/showthread.php?t=23826 > > But, I'm a little bit 'chicken' with xorg.conf, not > to mention messing with the dot clock et al....... > <CLUCK CLUCK CLUCK> > > Anyone want to venture a guess about the display settings, > suggested in the link? that I should use? A better way? > > Here's the (example) math I use to use: > # DisplaySize 426 266 > # width = (1680pix / 100pix/in) x [25.4mm/in] = 427 --> 426 > # hieght = (1050pix / 100pix/in) x [25.4mm/in] = 267 --> 266 > > > Here is what's working with the dvi-dvi cable: > > Section "Monitor" > Identifier "aticonfig-Monitor[0]-0" > Option "VendorName" "ATI Proprietary Driver" > Option "ModelName" "Generic Autodetecting Monitor" > Option "DPMS" "true" > HorizSync 30-81 > VertRefresh 56-75 > EndSection > > Section "Device" > Identifier "aticonfig-Device[0]-0" > Driver "fglrx" > BusID "PCI:2:0:0" > # Option "XAANoOffscreenPixmaps" "true" > EndSection > > Section "Screen" > Identifier "aticonfig-Screen[0]-0" > Device "aticonfig-Device[0]-0" > Monitor "aticonfig-Monitor[0]-0" > DefaultDepth 24 > SubSection "Display" > Viewport 0 0 > Depth 24 > Modes "1920x1080" "1680x1050" "1280x1024" "1024x768" > EndSubSection > EndSection > > > >
