On 03/30/10 14:55, stosss wrote:
On Tue, Mar 30, 2010 at 2:08 PM, Joseph <syscon...@gmail.com> wrote:
I'm running Windows XP on VirtualBox, it has a network "NAT" so the IP
address it gets:
IP: 10.0.2.15
Gateway: 10.0.2.2
DNS: 10.10.0.1 ?(Linux router)
I've tried to access the Windows IP by creating another subnet:
ifconfig eth0:1 10.0.2.0 up
but it doesn't work, I can not ping the Windows IP: ?10.0.2.15
(Windows firewall is OFF)
Any suggestions?
You could try using Bridged instead of NAT. Bridged would let you set
up the NIC on the VM to the same IP address range as the host using
the same NIC as the host.
If your host IP is 192.168.1.10 on eth0
You could set Bridged > eth0 on the VM settings panel and then set
your net config inside the VMs OS to 192.168.1.X on eth0
Yes, I'm aware of it.
I've setup iptables + squid so I can filter here they an connect to.
If I setup as Bridge, Windows gets the IP from the Router (dhcpd) and will
by-pass my filter :-/
My router does not filter outgoing traffic only incoming.
I setup on VirtualBox one interface as NAT and one as Bridge and Windows
browser selected the one without filer Bridge, so it is bypassing my filter.
--
Joseph
