Yes ext3 and via_sata are configured in the kernel and not as modules. All the filesystem sections are compiled directly into the kernel and all the device drivers I need for the motherboard.
Kevin. On 29/05/05, Bob Sanders <[EMAIL PROTECTED]> wrote: > On Sun, 29 May 2005 21:52:42 +0100 > Kevin Philp <[EMAIL PROTECTED]> wrote: > > > I have been using a 2.6.7 kernel for months quite happily. Recently I > > decided to upgrade to 2.6.11-r9 but I am having problems. When booting > > it stalls with > > > > VFS: Cannot open root device "2105" or unknown block > > > > Googling around I can see its a common problem and I have tried the > > following without success: > > > > 1. Disable devfs > > 2. Checked I have via sata in the kernel (via sata board with sata hard > > drive) > > 3. Checked I have IDE enabled > > 4. Checked I have ext3 extensions the same as on 2.6.7 kernel > > 5. Check LILO is correct > > > > Forgive the dumb questions - when you mention the via sata modules and ext3 > file > system - these are not modules but really in the kernel - "*", selected? > > And the VIA SATA is the one under the SCSI low-level drivers - SCSI_SATA_VIA? > > Bob > -- > - > -- > gentoo-user@gentoo.org mailing list > > -- gentoo-user@gentoo.org mailing list
