Hi,
I have i865PE based mobo + SATA HDD on /dev/sda (primary/master).
I had to setup BIOS to SATA+PATA (combined) mode, for my burner,
which is secondary/master.
BIOS sees both drives and even (older) Knoppix 3.7 is booting no problem
(ide-scsi module is used for CDRW handling on /dev/scd0).
I like to use CDRW in ATAPI mode, but kernel 2.6.11
(I tried vanilla-sources-2.6.11.7 and also gentoo-sources-2.6.11-r6)
do not recognize my burner, "dmesg |grep hd" shows only SATA HDD.
I tried to add hdx=cdrom (x={a,b,c,d}) to boot prompt, but it doesn't
help at all.
I also replaced the burner with another model without success.
If I replace it with PATA HDD, kernel recognizes it, but the HDD is
accessible via /dev/sdb (probably here the problem is - this is really
a bit strange for me).
There are my relevant kernel options:
CONFIG_IDE=y
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
CONFIG_BLK_DEV_IDECD=y (ata cdrom)
CONFIG_BLK_DEV_IDEPCI=y
4CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_IDEDMA_PCI_AUTO=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_IDEDMA_AUTO=y
CONFIG_SCSI=y
CONFIG_SCSI_PROC_FS=y
CONFIG_SCSI_MULTI_LUN=y
CONFIG_SCSI_CONSTANTS=y
CONFIG_SCSI_LOGGING=y
CONFIG_SCSI_SATA=y
CONFIG_SCSI_ATA_PIIX=y (i865 SATA)
CONFIG_SCSI_QLA2XXX=y (added by ghost)
CONFIG_BLK_DEV_SR=m (scsi cdrom)
Does anybody know, where the problem is ?
Any suggestions appreciated.
(.config of working SATA+PATA kernel would help me too.)
TIA noro
--
[email protected] mailing list
