I've tried to use paraview recently. I've compiled the qt4 GUI. Upon executing the binary, I get this error: LLVM ERROR: Allocation failed when allocating new memory in the JIT The binary terminates at the very beginning. I cannot even see the GUI. I'm using a paraview ebuild from the science overlay. There are no JIT related use flags or options. However I've also checked the llvm ebuild, and that has a pax-marking section, but only if test USE flag is enabled. Some test files gets marked in that case. LLVM has a separate option to enable or disable jit during the configure phase.
My question is related to the proper way of handling this error. Whether I should look for some parts of paraview to pax-mark? Whether I should try to disable JIT in LLVM? I also see according to equery, that some parts of mesa depends on LLVM (I'm using radeon). Is it possible, that I hurt mesa by disabling LLVM JIT? Thanks for any suggestions: Dwokfur -- dr Tóth Attila, Radiológus, 06-20-825-8057 Attila Toth MD, Radiologist, +36-20-825-8057
