Hi Brian, Thanks for the comments. Please see below prefixed by <RA>:
1. 6. Session Establishment A BFD session is boot-strapped using LSP-Ping. This specification describes procedures only for BFD asynchronous mode. Should you state explicitly that BFD Demand mode MUST NOT be used? <RA> I will spell out that BFD demand mode is out of scope. 7. Encapsulation ... The BFD control packet sent by the ingress LSR MUST be a UDP packet with a well known destination port 3784 [BFD-IP] and a source port assigned by the sender as per the procedures in [BFD-IP]. The source IP address is a routable address of the sender. The destination IP address is randomly chosen from the 127/8 range, This is written in IPv4 terms. What happens in an IPv6-only environment? There is no range of loopback addresses to borrow in IPv6, but you could use a ULA prefix. <RA> The procedures of RFC 4379 need to be used which is basically a destination IPv6 address from the range 0:0:0:0:0:FFFF:127/104. I will spell this out. Thanks for the catch. Will fix the idnits. Thanks, rahul On Thu, 1 May 2008, Brian E Carpenter wrote: > > > > > _______________________________________________ Gen-art mailing list [email protected] https://www.ietf.org/mailman/listinfo/gen-art
