On 9/26/2022 3:51 PM, Humza Ikram wrote:
I ran it again and it finished in a little under 3 hours.
Thank you for replying and clarifying.
Wow, that's long. You can see why it is helpful to do actual
runs starting from a checkpoint!
Regards - Eliot Moss
----------------------------------------------------------------------------------------------------
*From:* Eliot Moss <m...@cs.umass.edu>
*Sent:* Monday, September 26, 2022 5:00 PM
*To:* The gem5 Users mailing list <gem5-users@gem5.org>
*Subject:* [gem5-users] Re: Error while attempting to run "x86-ubuntu-run.py"
On 9/26/2022 5:18 AM, Humza Ikram wrote:
Dear all,
I have built gem5 with scons from|"https://gem5.googlesource.com/public/gem5
<https://gem5.googlesource.com/public/gem5>".
|
|
|
|By running "scons build/X86/gem5.opt -j7".|
|
|
|Itbuilds without any problems. I try to run the example code given in
"gem5/configs/example/gem5_library/x86-ubuntu-run.py"|
|By adding "gem5/build/X86/" to the PATH variable and running:|
|
|
|"gem5.opt x86-ubuntu-run.py" in the relevant directory. It gets stuck:
You perhaps did not wait long enough. it can take a long time
to simulate through the OS boot process - 15 to 20 minutes on
reasonably fast x86 processors - and there are places in that
boot process where there is no output for quite some time.
Best - Eliot Moss
_______________________________________________
gem5-users mailing list -- gem5-users@gem5.org
To unsubscribe send an email to gem5-users-le...@gem5.org
_______________________________________________
gem5-users mailing list -- gem5-users@gem5.org
To unsubscribe send an email to gem5-users-le...@gem5.org
_______________________________________________
gem5-users mailing list -- gem5-users@gem5.org
To unsubscribe send an email to gem5-users-le...@gem5.org
