Hello Gem5 community,
I'm trying to use the M5 utility meant for full system mode to signal work 
begin and end. I see in the documentation that the utility supports these 
parameters:
   
   - workbegin: Cause an exit evet of type, “workbegin”, that could be used to 
mark the begining of an ROI.
   - workend: Cause an exit event of type, “workend”, that could be used to 
mark the termination of an ROI.
But when I run the utility in X86 after compiling it for X86 those two options 
aren't available as commands. There is a "fail" option with a parameter that 
isn't mentioned in the documentation. Is that the way to simulate workbegin and 
workend?
Thanks in advance,  George M





_______________________________________________
gem5-users mailing list -- gem5-users@gem5.org
To unsubscribe send an email to gem5-users-le...@gem5.org
%(web_page_url)slistinfo%(cgiext)s/%(_internal_name)s

Reply via email to