HI, All,

I want to enable an Ethernet device to x86 full system simulation. After
searching the mail archive, I followed the ARM way, added the device in
dev/x86/Pc.py just like Arm Realview, and added code to attachIO(). The
config.ini file showed the device is there and connected on iobus.

But when booting the kernel (2.6.28.4) using atomic CPU, there was a
ioremap invalid address error. And after boot, the system can't see the
device (ifconfig eth0 shows nothing).

Has anyone successfully made this work? I am not familiar with the x86 IO
configuration. Any hints would be really helpful. Thanks a lot.

-- 
Regards,

Veydan
_______________________________________________
gem5-users mailing list
gem5-users@gem5.org
http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users

Reply via email to