Can anyone respond to the above comments and tell us what the use of the mcpat patch for?.Can gem5 dynamically call mcpat by taking the stats value and dump the power values. I dont see that happening.
Thanks Sudarshan Graduate student Electrical Engineering Univ of Massachusetts Amherst ---------- Forwarded message ---------- From: Sudarshan <[email protected]> Date: Tue, Feb 4, 2014 at 3:16 PM Subject: Re: [gem5-users] McPAT To: gem5 users mailing list <[email protected]> Following up with the above questions. I did install the patch 2021 and 2117 and build it. How to get the power analysis output?. Is there command line where i can call mcpat and not while running benchmarks? I did read in the patch that we can do recursive calls to mcpat. Can someone point out how do we call mcpat to dump power stats after n instructions? Thanks Sudarshan On Tue, Feb 4, 2014 at 11:10 AM, Hamid Motaman <[email protected]> wrote: > Hello every one, > > > > I installed the patch #2021 and #2117 and #2118 for Mcpat. I also did > regression test successfully. However, I am confused how this Mcpat works. > How can I get power analysis output? If I still need m5 xml parser so what > is the benefit of this patch? I would really appreciate if someone explain > it to me. > > > > Best Regards, > > Hamid > > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users >
_______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
