Hello There is no difference ,ALPHA is used to put in it all the configurations you need. You have to specify the full system in the ALPHA as shown "FULL_SYSTEM = 1" . You can check the per configuration section at http://www.m5sim.org/Build_System
Wish this helps. Thanks Best Regards Wael AMR On Mon, Aug 27, 2012 at 11:17 PM, Grace Lee <pinksky...@gmail.com> wrote: > Hi,**** > > ** ** > > This is my first time to use the GEM5.**** > > I want to run the Aplash-2 Benchmarks on gem5 on Ubuntu in full system > mode.**** > > I downloaded files from gem5 website and installed on Ubuntu(12.04 > Precise).**** > > **i) **Gem5-stable.tar.bz2**** > > **ii) **M5_system_2.0b3.tar.bz2**** > > ** ** > > Also downloaded and installed required software shown as below:**** > > **i) **Python: 2.4+, it may need to install > “python-dev” **** > > **ii) **Scons: 0.98.1+, you can update it with apt-get > (2.0.1) **** > > **iii) **SWIG: 1.3.31+, you can update it with apt-get > (1.3.40) **** > > ** ** > > To build gem5, I used below command:**** > > **Ø **scons build/ALPHA_FS/gem5.opt**** > > (or)**** > > **Ø **scons build/ALPHA_SE/m5.opt**** > > ** ** > > but both didn’t’ work. There was an error message that says that **** > > “ cannot find variables files > /pgks/gem5/gem5-stable/build/variables/ALPHA_SE or default file(s) / > pgks/gem5/gem5-stable/build/variables/ALPHA_SE”**** > > ** ** > > I was able to build gem5 with ALPHA.**** > > (> scons build/ALPHA/gem5.opt)**** > > ** ** > > However, if I want to run ALPHA_FS, what are the things I have to do to > make it work?**** > > What is different between ‘ALPAH’ and ‘ALPHA_FS’ ?**** > > Does the ‘ALPHA’ includes both ‘FS’ and ‘SE’ mode?**** > > ** ** > > Thanks,**** > > GL**** > > ** ** > > _______________________________________________ > gem5-users mailing list > gem5-users@gem5.org > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users >
_______________________________________________ gem5-users mailing list gem5-users@gem5.org http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
