in "config.ini", you can make sure whether the L2 controller is there.
The command is wrong. it should be "PROTOCOL = MOESI_CMP_token" rather
than "TOPOLOGY=MOESI_CMP_token"
Tao
On 05/18/2012 01:04 PM, Hamid Reza Khaleghzadeh wrote:
I have compile Gem5 as following:
scons ~/build/ALPHA/gem5.opt RUBY=True TOPOLOGY=MOESI_CMP_token
Also, ruby.stats and stats.txt are attached.
Could you tell me what is wrong?
On Fri, May 18, 2012 at 9:30 PM, Nilay Vaish <ni...@cs.wisc.edu
<mailto:ni...@cs.wisc.edu>> wrote:
On Fri, 18 May 2012, Hamid Reza Khaleghzadeh wrote:
I have using MOESI_CMP_token which support L2 cahce
On Fri, May 18, 2012 at 9:11 PM, Nilay Vaish
<ni...@cs.wisc.edu <mailto:ni...@cs.wisc.edu>> wrote:
On Fri, 18 May 2012, Hamid Reza Khaleghzadeh wrote:
Hi,
I found that ruby doesn't create L2 cache. I run
execute gem5 as
following:
./gem5.opt ruby_fs.py --caches --l2cache
--l2_cachesize=32MB
But I cannot find any system.l2_cntrl. Could you tell
me why?
This depends on the coherence protocol in use. The one you
are using does
not seem to have an L2 controller.
I think you need to check again. Either you did not compile
MOESI_CMP_token protocol. Or you are looking at the wrong file.
--
Nilay
_______________________________________________
gem5-users mailing list
gem5-users@gem5.org <mailto:gem5-users@gem5.org>
http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
--
Hamid Reza Khaleghzadeh
http://hkhaleghzadeh.webs.com
_______________________________________________
gem5-users mailing list
gem5-users@gem5.org
http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
_______________________________________________
gem5-users mailing list
gem5-users@gem5.org
http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
