On Fri, 19 Aug 2011, Markus Hitter wrote:
Am 15.08.2011 um 22:37 schrieb kqt4a...@comcast.net:
I was especially interested in the drillmill function but I have not been
able to get that to work
I check the box and only get plain drilling
Did you look into the "outline" G-code file? As drill-milling and outline
milling often uses the same tool, I've put the drill-mills there.
As a beginner this was not very intuitive
I wanted to drill mill but not cut out the outline so I ignored the outline
setting
If I adjust the outline settings properly I get drill milling but also outline
cutout
Thanks
Richard
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
