Sent this once but never saw it, so I'll try again. Don't know what happened to the first one. I was following the tutorial on [1]http://geda.seul.org/wiki/geda:gsch2pcb_tutorial#custom_gschem_symb ols and attempted to modify the dual op amp as directed in that tutorial. When I went to add the two op amps to the schematic I noticed that when I changed the second one to slot=2, that the output pin remained number 1, but the input pins changed as expected. I examined the opamp-sym.sym file that I had edited and found this: slot=1 T 200 1300 5 10 0 0 0 0 1 numslots=2 T 200 1500 5 10 0 0 0 0 1 slotdef=1:3,2,1 T 200 1700 5 10 0 0 0 0 1 slotdef=2:5,6,7 T 200 1900 5 10 0 0 0 0 1 footprint=SO8 T 200 2100 5 10 0 0 0 0 1 footprint2=DIP8 T 200 2500 5 10 0 0 0 0 1 symversion=0.2 T 200 2700 5 10 0 0 0 0 1 documentation=[2]http://www.onsemi.com/pub/Collateral/LM358-D.PDF T 200 2900 5 10 0 0 0 0 1 description=opamp T 1895 600 8 10 0 0 0 0 1 net=Vcc:8 T 1795 400 8 10 0 0 0 0 1 net=Vee:4 That's not the whole file, but just the last few lines. There are no other references to "slot" in the file. [cid:[email protected]] I'm very new at this, so I'm not really sure where to start looking for a solution. Thanks, Jim.
References 1. http://geda.seul.org/wiki/geda:gsch2pcb_tutorial#custom_gschem_symbols 2. http://www.onsemi.com/pub/Collateral/LM358-D.PDF
<<inline: slot2.jpg>>
_______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
