Hi,
Is there any way to tell PCB that which pins are "power" pins and which pins
are "signal" pins? Then tell PCB to select only those rats which connect power
pins or which connect signal pins?
This way power lines could be auto routed with wide tracks and signal lines
could be auto routed with narrow tracks.
Currently I know about 2 ways to solve it:
1. selecting manually the power rats one-by-one than auto route them with wide
track settings, then selecting the remaining rats and and auto route them with
narrow track settings
2. doing the auto routing for all rats, than increasing the width of power
tracks manually one-by-one
Both methods are time consuming, annoying and error prone. Is there a better
way?
Cheers,
Endre
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
