On Wed, 2008-07-23 at 14:49 -0400, Vincent Onelli wrote: > Thank you so mutch, this works > Here is another question, can I setup board size width and hight > larger then > is need and then draw an outline for the proper size required? This > will > accomodate any shape board > Thank you again. Vinny
Yes, just rename one of the layers "outline" (or add it as a new layer), and the right thing will happen. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
