DJ is right you can put it where ever you want. However some assembly shops would like to know where the center of the foot print is.
Steve Meier On Wed, 2008-06-25 at 18:02 +0200, Tamas Szabo wrote: > Hi, > > I just checked the footprint in newlib and found that in lot of the > cases pin 1 of a part is placed to (0,0). > > Is there any drawback if I put it somewhere else due to make the > calculation easier? > > I mean, for example, selecting one corner of the outline of a module > built on a small pcb (like GPS-, BT-modules) or connectors, etc., since > all unit are measured from that point? > > Thx, > > /sza2 > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
