On Tue, Mar 25, 2008 at 06:07:19PM -0400, John Luciani wrote: > gap in between. The three pad jumper consists of a half circle on each > end with a rectangular pad in between.
I'm sure you have a reason for using special pads, but I'd just use some SMT resistor footprint. I've made 3-pad strapping setups by putting a pull up and down in the schematic and then overlapping the common pad so a resistor can be installed either way. Of course they cannot just be bridged with solder. As for gaps, why not pull out an old unpopulated board and try a few existing footprints? QFP, TSSOP and maybe SO have gaps in the range you'd like to try. See what bridges well enough for your app. -- Ben Jackson AD7GD <[EMAIL PROTECTED]> http://www.ben.com/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
