Kyle Shannon wrote:
After a little digging, it appears that the netCDF driver does not
support the tag:
Lambert_Conformal:standard_parallel
it supports:
Lambert_Conformal:standard_parallel_1
and:
Lambert_Conformal:standard_parallel_2
I am not sure if the tag is out of specification, or if the driver needs
to be updated. I also notice OGRSpatialReference has a separate
function for setting a Lambert Conformal Conic with single parallel:
OGRErr SetLCC1SP( *double* dfCenterLat, *double* dfCenterLong, ...
but this is not referenced in the netCDF driver.
So, my next question is:
Can you specify the value of SP_1 and SP_2 as the same parallel in the
standard LCC, or do you have to set LCC1SP
Thanks everyone for your patience,
Kyle,
Good investigating. I'd suggest filing a ticket, ideally referencing
an example file. It should be fairly easily added.
Best regards,
--
---------------------------------------+--------------------------------------
I set the clouds in motion - turn up | Frank Warmerdam, [email protected]
light and sound - activate the windows | http://pobox.com/~warmerdam
and watch the world go round - Rush | Geospatial Programmer for Rent
_______________________________________________
gdal-dev mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/gdal-dev
