After commiting the last SH changes updates for 4.8 I was kindly
informed that the br tags were left open.  I've committed the attached
fix as obvious.

Cheers,
Oleg
? www_4_8_sh_changes_2_close_br.patch
Index: htdocs/gcc-4.8/changes.html
===================================================================
RCS file: /cvs/gcc/wwwdocs/htdocs/gcc-4.8/changes.html,v
retrieving revision 1.36
diff -u -r1.36 changes.html
--- htdocs/gcc-4.8/changes.html	5 Oct 2012 19:21:00 -0000	1.36
+++ htdocs/gcc-4.8/changes.html	5 Oct 2012 19:28:48 -0000
@@ -259,25 +259,25 @@
       model for the generated atomic sequences.  The following models are
       supported:
       <ul>
-        <li><code>soft-gusa</code><br>
+        <li><code>soft-gusa</code><br/>
         Software gUSA sequences (SH3* and SH4* only).  On SH4A targets this
         will now also partially utilize the <code>movco.l</code> and
         <code>movli.l</code> instructions.  This is the default when the target
         is <code>sh3*-*-linux*</code> or <code>sh4*-*-linux*</code>.</li>
 
-        <li><code>hard-llcs</code><br>
+        <li><code>hard-llcs</code><br/>
         Hardware <code>movco.l</code> / <code>movli.l</code> sequences
         (SH4A only).</li>
 
-        <li><code>soft-tcb</code><br>
+        <li><code>soft-tcb</code><br/>
         Software thread control block sequences.</li>
 
-        <li><code>soft-imask</code><br>
+        <li><code>soft-imask</code><br/>
         Software interrupt flipping sequences (privileged mode only).  This is
         the default when the target is <code>sh1*-*-linux*</code> or
         <code>sh2*-*-linux*</code>.</li>
 
-        <li><code>none</code><br>
+        <li><code>none</code><br/>
         Generates function calls to the respective <code>__atomic</code>
         built-in functions.  This is the default for SH64 targets or when the
         target is not <code>sh*-*-linux*</code>.</li>

Reply via email to