check $FWDIR/lib/control.map - ensure you are using the proper type of
authentication
if you want to force an auth type, you can put a comma-delimted line of the
remote modules IP addresses at the top
of this file.
x.x.x.x, y.y.y.y: */fwa1
redo the putkeys on the clients and server:
fw putkey -n local-ip -p [password] remote-ip
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
Sent: Friday, September 08, 2000 5:37 PM
To: [EMAIL PROTECTED]
Subject: [FW1] fetch
Just installed FW1 4.1 SP1 with FW on Solaris and Mgmt Server on NT 4.0.
When FW starts up, it gets an error -
"Authentication for command fetch failed"
Any ideas?
Bill Steele
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
