Hi everyone and happy new year! I made a couple of manual edits to a wm.mgz file and then relaunched part of that subject's recon (-autorecon2-wm -autorecon3). After it finished, however, the wm.mgz had lost its manual edits - even though I had saved the edited version under the same name, in the right folder. Any ideas why it got overwritten? Comparing filesizes, the post-recon wm.mgz was different not just from my edited version, but also slightly different from the pre-edited wm.mgz!
I then redid my edits and repeated the procedure. Strangely, this time the wm.mgz edits were kept, however the redone surfaces still looked bad, as if the wm.mgz hadn't been edited at all. I am running FS 5.3.0 from inside VirtualBox 4.2.12, on a Windows PC. Recon jobs are run remotely on a server running FSL software and output files are then copied over to my local PC. Any help much appreciated, thanks in advance! Tudor
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
