Hi Darshan,
The ribbon.mgz is created/updated in autorecon3. -autorecon2-wm ends at
the inflate2 step, the last step before autorecon3.
-Louis
On Thu, 20 Sep 2012, Darshan P wrote:
I had a case which did not estimate the white matter clearly . So i used
tkmedit to add the voxels to the wm.mgz.
After running program using autorecon2-wm the new surfaces were created ,
but the ribbon.mgz was not .
Shouldn't the ribbon update too , because it shows the thickness of gm.
regards
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
