To see cortical thickness I used "File"--> "Load Curvature" (rh.thick), as you
have suggested. In this way, I see the cortical thickness' value near the
"curvature" indication, voxel-by-voxel. It's ok?
And,
when I write the command line in tkmedit: "tkmedit SUBJECT_ID
brainmask.mgz -surfs", I see the brainmask image and two colored line, a
red one and a yellow one. The first one is th edge of cortical surface;
the other one is the white and grey matter's edge. Between these 2
lines, the software calculates the cortical thickness.
Is this ok?Have I understood well?
Thanks.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
