On 2023-06-12 06:16:16, Dmitry Baryshkov wrote:
> CCF can try enabling VCO before the rate has been programmed. This can
> cause clock lockups and/or other boot issues. Program the VCO to the
> minimal PLL rate if the read rate is 0 Hz.
>
> Reported-by: Degdag Mohamed <[email protected]>
> Fixes: 1ef7c99d145c ("drm/msm/dsi: add support for 7nm DSI PHY/PLL")
> Signed-off-by: Dmitry Baryshkov <[email protected]>
This unfortunately regresses my Xperia 5 (sofef01 panel driver that's
on the lists) to now run at 30~33Hz instead of 60Hz. I can provide
debugging and clk trees later, if needed.
- Marijn
> ---
> drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
> b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
> index 3b1ed02f644d..6979d35eb7c3 100644
> --- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
> +++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
> @@ -395,11 +395,16 @@ static void dsi_pll_phy_dig_reset(struct dsi_pll_7nm
> *pll)
> wmb(); /* Ensure that the reset is deasserted */
> }
>
> +static unsigned long dsi_pll_7nm_vco_recalc_rate(struct clk_hw *hw,
> + unsigned long parent_rate);
> static int dsi_pll_7nm_vco_prepare(struct clk_hw *hw)
> {
> struct dsi_pll_7nm *pll_7nm = to_pll_7nm(hw);
> int rc;
>
> + if (dsi_pll_7nm_vco_recalc_rate(hw, VCO_REF_CLK_RATE) == 0)
> + dsi_pll_7nm_vco_set_rate(hw, pll_7nm->phy->cfg->min_pll_rate,
> VCO_REF_CLK_RATE);
> +
> dsi_pll_enable_pll_bias(pll_7nm);
> if (pll_7nm->slave)
> dsi_pll_enable_pll_bias(pll_7nm->slave);
> --
> 2.39.2
>
