Adding dsi controller and phy entries for idp dt.

Signed-off-by: Harigovindan P <harig...@codeaurora.org>
---
 arch/arm64/boot/dts/qcom/sc7180-idp.dts | 56 +++++++++++++++++++++++++++++++++
 1 file changed, 56 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts 
b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index 388f50a..9f42367 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -7,6 +7,7 @@
 
 /dts-v1/;
 
+#include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/regulator/qcom,rpmh-regulator.h>
 #include "sc7180.dtsi"
 #include "pm6150.dtsi"
@@ -232,6 +233,50 @@
        };
 };
 
+&dsi_controller {
+       status = "okay";
+
+       vdda-supply = <&vreg_l3c_1p2>;
+
+       panel@0 {
+               compatible = "visionox,rm69299-1080p-display";
+               reg = <0>;
+
+               vdda-supply = <&vreg_l8c_1p8>;
+               vdd3p3-supply = <&vreg_l18a_2p8>;
+
+               pinctrl-names = "default", "suspend";
+               pinctrl-0 = <&disp_pins_default>;
+               pinctrl-1 = <&disp_pins_default>;
+
+               reset-gpios = <&pm6150l_gpio 3 GPIO_ACTIVE_HIGH>;
+
+               ports {
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+                       port@0 {
+                               reg = <0>;
+                               panel0_in: endpoint {
+                                       remote-endpoint = <&dsi0_out>;
+                               };
+                       };
+               };
+       };
+
+       ports {
+               port@1 {
+                       endpoint {
+                               remote-endpoint = <&panel0_in>;
+                               data-lanes = <0 1 2 3>;
+                       };
+               };
+       };
+};
+
+&dsi_phy {
+       status = "okay";
+};
+
 &qspi {
        status = "okay";
        pinctrl-names = "default";
@@ -289,6 +334,17 @@
 
 /* PINCTRL - additions to nodes defined in sc7180.dtsi */
 
+&pm6150l_gpio {
+       disp_pins_default: disp-pins-default{
+               pins = "gpio3";
+               function = "func1";
+               qcom,drive-strength = <2>;
+               power-source = <0>;
+               bias-disable;
+               output-low;
+       };
+};
+
 &qspi_clk {
        pinconf {
                pins = "gpio63";
-- 
2.7.4

_______________________________________________
Freedreno mailing list
Freedreno@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/freedreno

Reply via email to