Hi Andriy,
Just to be clear, this would mean that in my sc_post_init, I should not
utilize callout_reset, which utilizes r92c_handle_c2h_report, correct?
This appears to be how rtl
If so, how do I know when a C2H event arrives? (I am not too familiar
with C2H or how it works yet).
As always, thank you very much.
On 10/29/2017 07:46 PM, Andriy Voskoboinyk wrote:
Sun, 29 Oct 2017 08:34:21 +0200 було написано Farhan Khan
<kha...@gmail.com>:
Hi,
You should not use polling for RTL8188EE - it was mainly used for
RTL8192C* (since there is no documented way to get events from it)
and can be enabled on RTL881(1,2)A (but just is not needed here).
Look into rtwn/rtl8188e/r88e_rx.c - I think you can call
r88e_ratectl_tx_complete() and/or r88e_handle_c2h_report() indirectly
from rtwn_pci_intr() when C2H event arrives.
Hi all,
I am trying to extend the rtwn driver to add RTL8188EE support. I am
still getting this error whenever I enable the WiFi card:
rtwn0: r92c_handle_c2h_task: C2H report 0 (len 0) was not handled
From my reading of the code, it appears that the driver is trying to
read a status-value from the card, but it fails to return a valid
result. Is there something that I need to do to initialize this? If
so, what exactly? This appears to be a firmware-specific routine and I
have enabled the firmware.
I have been on this for an extended period of time and am stuck :(
Thank you!
--
Farhan Khan
PGP Fingerprint: B28D 2726 E2BC A97E 3854 5ABE 9A9F 00BC D525 16EE
_______________________________________________
freebsd-wireless@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-wireless
To unsubscribe, send any mail to
"freebsd-wireless-unsubscr...@freebsd.org"
_______________________________________________
freebsd-wireless@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-wireless
To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org"
